News from internet for paint bucket mould
preform mould
>cap mould
plastic mold manufcturer

injection molding

plastic mold

plastic molding


cap mould


评论

发表评论

此博客中的热门博文

How to deal with transparent injection molding

图片
How to deal with transparent plastic material PMMA,PC and PET injection molding Due to their high light transmittance, the requirement for transparent plastic surface need to be strict, it can not has any markings, voids, whitening, black spots, discoloration, poor gloss and other defects. Thus the whole injection molding process for raw materials, equipment, molds, and even product design, could be said very strict and sometimes even very special. Further more, because of most transparent plastic with high melting point, poor mobility, to ensure the surface quality of the products, it often needs make minor adjustments at high temperature, injection pressure, injection speed and other parameters, so that it could both fill  plastic injection mold  properly and will produce proper stress which would cause no deformation and cracking. How to dry the raw material Due to any impurities in plastics, they may affect the transparency of the product .Therefore on storage, tran...
阅读全文

Primary Parting Plane Runners

图片
In many cases, the mold design dictates the gating position, although ideally, the optimum gate position should be determined based on part requirements and afterwards the mold design should be selected to provide for the gate desired position. Available gating positions, and gate designs, are significantly influenced by whether the runner travels along the primary parting plane of the mold (the parting plane where the part forming cavity is defined) or whether it does not travel along this plane. In the dominant runner type used in the industry the runner and part forming cavities are located along the same primary parting plane. Primary parting planes, often referred to as the parting lines, are where the mold opens and closes to allow ejection of the molded part and/or of the runner. The primary parting plane is the one where the molded part is formed and ejected. The primary parting plane runner is used in two plate cold runner molds. A cold runner mold is defined as a mold i...
阅读全文

plastic 2 shot injection molding

Two-shot silicone-thermoplastic injection molding is a method to create a silicone-and-thermoplastic part in one process. These parts are traditionally plastic molding individually and assembled as one medical device component. The two-shot process eliminates secondary operations and assembly, which are often the main contributors to increasingly higher part costs. By reducing the chance of misalignments seen in traditional inserts or in overmolding processes, the two-shot process enables improved performance and consistent quality. The process offers the ability to produce complex mouldings from two different polymers at the same time during one machine cycle. Separate, but compatible, materials or colours are chemically bonded or mechanically interweaved during the forming process when the second material is injected into the mould, which avoids the need for further assembly or postprocessing. Alternatively, incompatible materials can be mechanically connected by two-shot moulding ...
阅读全文