链接

preform mould
plastic mould
injection molding
plastic molding
crate mould
pipe fitting mould
dust bin mould
paint bucket mould
chair mould
blow mould
plastic mold manufcturer
thin wall mould
basket mould

塑料模具
塑料模具厂
塑料椅模具

评论

发表评论

此博客中的热门博文

runner stick

图片
What is the runner stick runner stick refer to a phenomenon in which the runner of the molded article fails to separate from the mold. If the holding pressure is applied for a long time ,so that the size of the runner is increased, or the runner path portion of the mold is scratched or undercut, resistance is generated, so that the runner cannot be peeled off when the mold is opened. Reasons for the  runner sticking Insufficient solidification of runner When the main runner is not fully cured, the shrinkage is small at this moment, and the runner is close stick to the mold, and the strength is also low. Therefore, if the runner is to be ejected at this time, it will be very easy to break. In this way, the runner will remain on the channel. Resin temperature, mold temperature, and cycle (cooling time) have an effect on the solidification of the main flow.  Excessive  pressure holding The main runner channel is separated from the barrel nozzle directl...
阅读全文

How to Join Plastic Parts

After plastic mold is ready,Splicing is arguably the most mature and simplest ways of fabricating or fastening two injection molding pieces together. Infact, splicing methods have been known even before other methods like welding, bolting or soldering. The concept of splicing involves the connection of pieces by using the surface adhesion between the plastic molding parts and the adhesives’ firmness or cohesiveness. One of the best features in splicing is an even distribution of stress. In addition, other benefits are that totally different materials can be brought together, large splicing areas can be made quickly, and the adhesive itself fills uneven surfaces. Nevertheless, splicing also involves certain pitfalls. In certain cases, the strength is limited and not all materials are suitable for splicing (Polyolefins), and proper storage of the chemicals is vital. Changes in temperatures will render problems for moist adhesives. Also, a different expansion between the plastic and the...
阅读全文

Primary Parting Plane Runners

图片
In many cases, the mold design dictates the gating position, although ideally, the optimum gate position should be determined based on part requirements and afterwards the mold design should be selected to provide for the gate desired position. Available gating positions, and gate designs, are significantly influenced by whether the runner travels along the primary parting plane of the mold (the parting plane where the part forming cavity is defined) or whether it does not travel along this plane. In the dominant runner type used in the industry the runner and part forming cavities are located along the same primary parting plane. Primary parting planes, often referred to as the parting lines, are where the mold opens and closes to allow ejection of the molded part and/or of the runner. The primary parting plane is the one where the molded part is formed and ejected. The primary parting plane runner is used in two plate cold runner molds. A cold runner mold is defined as a mold i...
阅读全文